LetteringBoats

Help

Installation guide

Most boat names take about 20 minutes to apply. Here's how to get a bubble-free, perfectly level result.

What you'll need

  • A felt-edge squeegee (included in our installation kit)
  • Masking tape and a tape measure or level
  • Isopropyl alcohol or a surface preparation kit
  • Optional for large or multi-color decals: a spray bottle with water and a drop of dish soap (wet method)

Step by step

  1. Prepare the surface. Remove old lettering and adhesive. Wash with soapy water, then wipe with isopropyl alcohol or a wax and grease remover. The surface must be clean, dry and wax-free.
  2. Check the temperature. Apply between 50°F and 90°F, out of direct sun and wind. Vinyl is stiff when cold and stretches when hot.
  3. Position with masking tape. Place the decal (still on its backing) and measure from the waterline and edges until level. Run a strip of masking tape along the top edge to form a hinge.
  4. Remove the backing. Flip the decal up on its hinge and peel the paper backing away at a sharp angle, keeping the lettering on the clear transfer tape.
  5. Squeegee from the center out. Lower the decal and press it down with firm, overlapping squeegee strokes from the center toward the edges to push out air.
  6. Remove the transfer tape. Wait a few minutes, then peel the transfer tape back flat against itself at 180°. If a letter lifts, lay the tape back down and squeegee again.
  7. Finish and cure. Press any small bubbles out toward the nearest edge or prick them with a pin. Avoid washing or pressure-washing for 72 hours.

Layered (outlined) lettering

Multi-color designs arrive as one layer per color, each on its own transfer tape with registration marks. Apply the bottom layer (the outermost outline or shadow) first, then align each next layer to the marks and repeat.

The wet method

For decals wider than about 36 inches, lightly mist the surface and the adhesive side with soapy water. This lets you slide the decal into position. Squeegee the water out firmly and allow extra time (30–60 minutes) before removing the transfer tape.

Need help?

Contact us with a photo of your surface and we'll advise on placement and method.