Help
How to measure
Five minutes with a tape measure gets you lettering that fits your boat and meets the size rules.
Step by step
- Find the flat space. Choose where the lettering goes and measure the flat, open area: its width and its height. Stay clear of rub rails, swim platforms, ladders, drains, cleats and tight curves.
- Leave a margin. Subtract a couple of inches on every side so the lettering doesn't crowd edges or hardware. What's left is the largest size that will fit.
- Mock it up. Cut a piece of paper or painter's tape to that size and tape it in place. Step back and check it reads well from the dock or the next slip.
- Set the size in the editor. Enter the width (or height) in the Size tool. The finished size includes outlines and shadow, so what you set is exactly what we cut.
Size rules to know
- State registration numbers: plain block characters at least 3 inches tall, in a color that contrasts with the hull, on both sides of the forward half of the boat, with letters separated from numbers by a space or hyphen (33 CFR 173.27). Our registration numbers are spaced this way automatically.
- USCG documented vessels: the name and hailing port marked together on the outside of the hull, in letters at least 4 inches tall (46 CFR 67.123). See documented vessel lettering.
- Official number: “NO.” and the official number in block numerals at least 3 inches tall, on a visible interior structural part of the hull (46 CFR 67.121). See our documentation number.
States can add their own rules; check with your state boating agency.
Curved surfaces
Cast vinyl follows gentle curves well. On a strongly curved or ribbed surface, keep each line of lettering on the flattest band you can, and measure along the surface rather than straight across.
Not sure?
Send us a photo with a tape measure in the shot and we'll suggest a size. When you're ready, see the installation guide.

